RFMW, Ltd. announces design and sales support fortwo internally matched, high IP3 low noise amplifiers from TriQuint. The TQL9042 and TQL9043 both feature bypass switches and shut-down pins offering receivers the highest level of sensitivity performance. The TQL9042 offers 19 dB gain over 0.5 to 2 GHz with a market leading 0.42 dB noise figure. The TQL9043 provides frequency coverage from 1.5 to 2.7 GHz with >18 dB gain and 0.5 dB noise figure.
RFMW, Ltd. announces design and sales support for the TGA2813, a 100 W GaN power amplifier targeted for RADAR applications from 3.1 to 3.6GHz. TriQuint’s TGA2813 offers 55% PAE supporting both short and long pulse operation with good thermal properties. Large signal gain is up to 22 dB. 30 V bias draws a quiescent current of 135 to 550 mA as TriQuint’s bias flexibility supports a variety of system requirements.
RFMW, Ltd. announces design and sales support for 6 GHz broadband wireless filters from Sangshin Elecom. The MBP33RC6162S525A is an excellent choice for wireless backhaul applications where flexibility in channel planning and selection is critical. The MBP33RC6162S525A from Sangshin Elecom covers the frequency range from 5.9 to 6.425 GHz in a small 8.5 mm x 5.6 mm package.
RFMW, Ltd. announces design and sales support fortwo new 6-bit phase shifters from TriQuint. Both the TGP2105-SM and TGP2107-SM offer 360 degree coverage with 5.625 degree LSB. Supporting X and Ku bands, the TGP2105-SM and TGP2107-SM span 6-18GHz and offer <10 dB insertion loss. Input IP3 is >41 dBm and both phase shifters P1dB compression points >25 dBm.
RFMW Ltd. announces design and sales support for the TGA2611, 2 to 6 GHz LNA utilizing TriQuint’s GaN25 technology. GaN processes provide a highly robust input coupled with low noise figure and high gain, ideal characteristics for S- and C-Band radar receivers or broadband communication receivers.
RFMW Ltd. announces design and sales support for a new line of dual use RF absorber + thermally conductive pad material from MAST Technologies. Trademarked Suppress-n-Sink, the target application is reducing harmful reflections from heat-sinks and heat-spreaders used on RF components.
RFMW, Ltd. announces design and sales support for TriQuint’s TGA2567-SM, an AlN packaged, 2 to 20 GHz low noise amplifier (LNA). The TGA2567-SM provides 19 dBm P1 dB output power with 17 dB of small signal gain. Greater than 16 dB of adjustable gain can be achieved by varying Vg2. Typical mid-band noise figure is 2 dB while OIP3 is specified at 29 dBm.
RFMW Ltd. announces design and sales support for P1dB’s 100 W, low PIM termination. Covering 0.8 to 2.6GHz, the P1dB P1LP-Term-716J100W features low PIM performance of <163dBc at +43dBm/tone. VSWR performance is 1.09:1 from a 7/16 female connector.
RFMW Ltd. announces design and sales support for Sunny Electronics SVP-53 series of FastClock™ voltage controlled crystal oscillators (VCXO’s).The SVP-53 uses a new, state-of-the-art, factory-configurable silicon technology that allows for a wide choice of frequency, voltage and output combinations. The SVP-53 series of FastClock™ VCXO’s offers customers the ultimate flexibility with delivery of a high performance VCXO in as little as five days.
RFMW Ltd. announces design and sales support for Skyworks SKY12215-478LF, a 125 W SPDT switch covering 0.9 to 4.0 GHz. Based on silicon PIN diode technology, the SKY12215-478LF features low insertion loss of 0.4 dB, minimizing receiver noise figure in Rx applications.