QPF4550 integrates a 5 GHz PA, single pole two throw switch  and bypassable low noise amplifier into a single device. 

The PSF42B04S interdigital filter has a pass band of 40 to 44 GHz with 50 Ω characteristic impedance. Handling a maximum input power of 2 Watts, this SMT filters’ insertion loss is < 2.2 dB and boasts > 30 dB upper and lower bandpass rejection.

The SiT5356 series oscillators deliver ±100 ppb stability performance and can be factory-programmed to any combination of frequency (from 1 to 60 MHz), voltage and pull range.

The R1920SMUA5CR  delivers -121 dBc/Hz typical phase noise at 10 KHz offset at its operating range of 1920 MHz.

MT3A-0113HPA delivers exceptional IMD suppression with low conversion loss and high IP3, RF and LO input frequencies. 

The Qorvo QPA2309 power amplifier offers 100 W of pSat RF power from 5 to 6 GHz in a small 7 x 7 mm QFN package. 

The 40AH-03 is a 2.92 mm male to 2.92 mm female attenuator with 3 dB nominal attenuation from DC to 40 GHz.

The KA113 is a GaAs pHEMT broadband low noise amplifier with high linearity in a 3 x 3 mm hermetic surface-mount technology package for harsh environments. 

The BAWplexer enables single antenna implementation combining both 2.4 GHz and 5 to 7 GHz Wi-Fi applications for simultaneous usage of Wi-Fi and LTE signals without interference.

The Qorvo QPA3358 provides 34 dB of flat gain and low noise of 4 dB for DOCSIS 3.1 amplifiers and broadband CATV hybrid modules from 47 to 1,218 MHz.