RFMW, Ltd. announces design and sales support forSkyworks SKY12213-478LF, a single-pole, single-throw (SPST) switch capable of handling up to 150 W of RF energy. The SKY12213-478LF spans the frequency range of 500 to 6000 MHz with a typical isolation of 23 dB. Based on silicon, SKY12213-478LF is controlled with a single positive power supply and draws minimal current yet insertion loss remains.
RSS
Model SFA-243403215-28SF-W1 is an active frequency multiplier to cover the output frequency range of 24 to 40 GHz. The required input power is +5 dBm and achieved output power is +13 dBm, which is sufficient to drive a Ka band balanced mixer to form a low cost down converter module.
Model STE-SF906-00-N1 is a D band frequency extender, which extends the input frequency of 12 to19 GHz to a full waveguide bandwidth, 110 to 170 GHz operation. The frequency extender combines high performance millimeter passive multipliers, amplifiers and filters to extend the low frequency sweeper or synthesizer to D band frequency band.
Model SOD-01213-22-S1 is a 37 GHz dielectric resonator oscillator (DRO). The oscillator is a free running oscillator and the high frequency stability is achieved by implementing a high quality dielectric resonator. The oscillator exhibits +13 dBm output power and low phase noise of -95 dBc/Hz at 100 KHz offset.
Model SSP-24303-42-D1 is a low cost, production ready K band FMCW ranging and directional sensor module. The center frequency of the module is set at 24.125 GHz with +/-150 MHz frequency modulation bandwidth and +3 dBm nominal output powers. The sensor operates from a single +5 .0 Vdc power supplier and typically draws 250-mA current and requires 0 to +15 volts voltage swing for electrical tuning.
Model SSP-24305-42-S1 is a low cost, production ready K band FMCW ranging sensor module. The center frequency of the module is set at 24.125 GHz with +/-150 MHz frequency modulation bandwidth and +5 dBm nominal output power. The sensor operates from a single +5 .0 Vdc power supplier and typically draws 250-mA current and requires 0 to +15 volts voltage swing for electrical tuning.
Model SOL-24307-42-VG is a low cost, production ready K band Varactor tuned Gunn oscillator. The center frequency of the VCO is set at 24.125 GHz with +/-150 MHz frequency modulation bandwidth and +7 dBm nominal output powers. The VCO operates from a single +5 .0 Vdc power supplier and typically draws 250-mA current and requires 0 to +15 volts voltage swing for electrical tuning.
Model SFS-75311416-10VFSF-S1 is a W-Band, subharmonically pumped mixer. The mixer employs high performance GaAs Schottky beamlead diodes, balanced configuration to produce superior RF performance. The subharmonically pumped mixer is capable for full RF waveguide band operation for RF frequencies from 75 to 110 GHz with half of the LO frequency: 37.5 to 55.0 GHz. The conversion loss measured was 12 to 16 dB at +13 dBm LO pumping level typically.
Model SFB-06-E2 is a D-Band, externally biased balanced mixer. The mixer employs high performance GaAs Schottky beam lead diodes, balanced configuration and proprietary bias circuitry to produce superior RF performance with very low LO pumping level. The low LO pumping level is desirable feature at higher millimeter-wave bands.
Model SOM-77302320-12-S1 is a free running E band mechanically tuned Gunn oscillator with output power 20 dBm and tuning bandwidth +/- 1 GHz. The mechanical tuning is accomplished via a self-locking tuning screw or micrometer. The bias voltage and current to operate the oscillator is at +10 Vdc and 200 mA typically. The oscillator is also bias tunable to allow frequency modulation via its bias port.