Check out these opportunities to train in topics such as antenna design, MIMO, active radar systems, phased arrays, test and measurement, amplifier design, and phase noise challenges with a conference pass at EDI CON USA.
While pursuing design wins to generate production revenue, mobile filter start-up Resonant plans to sell shares of common stock in a public offering, although the timing and size have not been defined. The funds will be used for working capital, capital expenditures, product development and acquisitions.
Cobham Wireless has delivered its massive MIMO test solution to China Mobile Research Institute, to enable the operator to benefit from the capacity and performance gains of digital massive MIMO technology.
In an ironic twist, Cree has purchased Infineon’s RF power business for €345 million, a year after Infineon’s attempt to buy Cree’s Wolfspeed RF business was blocked by the U.S. government, citing national security concerns.
While 5G promises data rates of 10 Gbps and latencies down to 1 ms, will it improve communication? You know, communication that leads to human understanding. Perhaps we also need to invest in user protocols.
ZTE Co. Ltd. has reached a milestone by successfully completing the implementation of a DL Cat-18 device. Rohde & Schwarz (R&S) was selected to verify the new ZTE 1.2 Gbps Smartphone with a test setup based on a R&S CMW500 mobile communication tester.
At Mobile World Congress, the Qualcomm/TDK Joint Venture, RF360 Holdings, announced what the company said is the first hexaplexer, covering FDD cellular bands 25, 30 and 66. The six-band filter uses SAW and BAW technologies.
Rohde & Schwarz and Huawei Technologies Co. Ltd. announced the successful demonstration of 1.6 Gbps LTE-A-Pro downlink throughput, using Huawei Balong 765, the industry’s first LTE modem to support category 19 at 1.6 Gbps technology.
Achieving sufficient capacity to meet the forecast backhaul needs over the next few years will be a major challenge. This white paper describes the technique of Air Division Duplexing (ADD), which makes use of MIMO and spatial multiplexing techniques to achieve simultaneous transmission and reception of data on each carrier frequency, and has been shown to achieve full duplex data rates1 in excess of 1 Gb/s in a 28 MHz channel
allocation2 in the microwave bands.
While LTE-Advanced brings the promise of higher data rates, designing devices for use in LTE-A offer new test challenges. This paper provides an overview of LTE MIMO and carrier aggregation technologies and describes different methodologies for testing these new capabilities including multi-antenna techniques, MIMO spatial multiplexing, beam steering, as well as the different carrier aggregation modes.
This white paper presents an overview of system level design for
wireless communications equipment. It will be useful not just to those involved in the development of new communications systems, but also to designers of new products using existing systems, or anybody seeking to develop new architectures and/or components to reduce product cost and/or size. It also describes the benefits and implications of developing highly integrated System on a Chip (SoC) solutions, which dominate in today's high volume communications products.
With many groups now beginning to consider the drivers for 5th Generation wireless networks, this timely document includes contributions from 20 IWPC member organizations from around the world and aims to advance certain understandings and concepts for adoption in wireless systems to be deployed beyond the year 2020. This 89 page document covers a broad range of 5G topics with emphasis on mm-wave.
Now that the need for ultra high capacity radios has become an unofficial requirement with a potentially large market backing it, the call for more spectrum savvy radios is in order. Traditional wisdom would have us assume that the legacy pure-play millimeterwave equipment vendors have this market clenched; however, every time there is a technology shift, as is occurring with the E-Band market, it opens the field up to new market leaders and a new competitive landscape. Thus, we have seen traditional microwave vendors throw their hats into the millimeterwave ring with various levels of commitment from OEMing/private labeling traditional millimeterwave vendors’ radios to designing their own millimeterwave radios.
Wireless consumer's insatiable demand for bandwidth has spurred unprecedented levels of investment from public and private sectors to explore new ways to increase network capacity. Service providers, now deploying fourth generation networks, are already beginning to look toward and plan for fifth generation networks (5G) to meet the escalating demand. Researchers at TU Dresden (TUD) have begun investigations into 5G technologies using a graphical system design approach and National Instruments' software defined radio platforms. Using the NI platform, TUD researchers significantly compressed the time to transition from concept to prototype.
This application note is designed to provide you with the latest insights on how to best address the long list of test requirements when testing the voice quality of LTE UE, with the right VoIP test building blocks. Successfully providing voice support on LTE will require UE developers to bring together a host of new features and capabilities. Many of these items have been around for a while but have not yet been applied to mobile networking. Others are completely new. Regardless, bringing them together will likely cause significant test pain, as they will need to be tested in conjunction with LTE and/or IMS to be fully exercised.
A system that utilizes OFDM/OFDMA, such as the E-UTRA (LTE) downlink or the IEEE 802.11a/g and the IEEE 802.16 physical
layers, transmits OFDM symbols, each comprising a number of modulated sub-carriers carrying data or pilot symbols, with
inter-subcarrier spacing being equal to or an integer multiple of a fixed frequency. The channel bandwidth (B) is determined by
the number of 'occupied' (modulated) subcarriers and the subcarrier spacing.
The IP Multimedia Subsystem (IMS) dates
from 3GPP release 5 almost a decade ago,
but is now becoming a reality with the rollout
of IMS-based LTE networks. IMS enables
convergence on multiple fronts, including
access types (fixed, mobile), service types,
application control functions and convergence
between telephony and traditional data
delivery. This paper presents a high-level technical
view of the IMS architecture as seen by LTEcapable
User Equipment (UE).
This white paper summarizes the
technology options for supporting voice
and short message service (SMS) in LTE,
including circuit switched fallback (CSFB),
SMS over SGs, and voice over LTE
(VoLTE). It includes background
information on the standardization
process, and the commercial implications
for the different options. The white paper
also addresses test and measurement
requirements resulting from the support of
voice and SMS in LTE.