- Buyers Guide
Articles Tagged with ''voltage''
Crystek's CVCO55CC-2950-2950 Voltage Controlled Oscillator (VCO) operates at 2950 MHz with a control voltage range of 0.5 V~4.5 V This VCO features a typical phase noise of -115 dBc/Hz @ 10 KHz offset and has excellent linearity. Output power is typically +7 dBm.
Linear Technology Corp. announces the LT8311, a high efficiency secondary-side MOSFET driver that operates without the need for primary control in an isolated synchronous forward converter. The LT8311’s unique preactive mode eliminates the need for a signal transformer for primary to secondary-side communication by sensing signals on the secondary side to control synchronous rectification. This mode reduces component count and solution size.
Linear's 9 to 72 V ideal diode bridge controller now specified for military & automotive applications
Linear Technology Corp. announces the automotive (H-grade) and high reliability military (MP-grade) versions of the LT4320, an ideal diode bridge controller for 9 to 72 V systems. The LT4320 replaces a full-wave diode bridge rectifier with a low loss N-channel MOSFET bridge to reduce the power and voltage losses by a factor of ten or more. Power supply size is reduced as the enhanced power efficiency eliminates bulky heat sinks.
Linear Technology Corp. announces the LT8309, a flyback secondary-side synchronous rectifier driver that replaces the output diode with a MOSFET, allowing up to 10A output current without the use of a heat sink. The maximum output current of a flyback power supply has been limited by the power loss and heat generated from the output diode when no heat sink is used.
KCB Signal Solutions announces a new, unique envelope tracking product line aimed at the emerging medium power RF transmitter market. The product line will be aimed at RF transmitters that must deal with complex waveforms, such as LTE, while transmitting between two to eight watts of average RF power.
Crystek's CVCO55CC-2700-2700 voltage controlled oscillator (VCO) operates at 2700 MHz with a control voltage range of 0.5 ~4.5 V. This VCO features a typical phase noise of -118 dBc/Hz @ 10 KHz offset and has excellent linearity. Output power is typically +7 dBm.
Crystek's CVCO55CC-3850-3850 voltage controlled oscillator (VCO) operates at 3850 MHz with a control voltage range of 0.5 ~ 4.5 V. This VCO features a typical phase noise of -110 dBc/Hz @ 10KHz offset and has excellent linearity. Output power is typically +7 dBm.
Linear Technology Corp. announces the LT8710, its first synchronous SEPIC, inverting, boost and flyback multi-topology DC/DC controller. This synchronous device replaces the output diode with a high efficiency P-channel MOSFET, increasing efficiency, maximum output current (up to 10A) and eliminating the heat sink typically required in medium to high power applications, making the LT8710 highly versatile for a wide range of power supply designs.
Linear Technology Corp. introduces the LTC3875, a dual output current-mode synchronous step-down DC/DC controller that enables the use of very low DC resistance (DCR) power inductors by using a novel DCR sensing architecture that enhances the signal-to-noise ratio of the current sense signal. Power inductor DCR, as low as 0.2 milliohms can be used without a sense resistor to maximize converter efficiency and increase power density. This new DCR sensing technique dramatically reduces the switching jitter normally associated with low DCR sensing applications.
Crystek's CVCO55CC-2380-2380 VCO (voltage controlled oscillator) operates at 2380 MHz with a control voltage range of 0.3 ~ 4.7 V. This VCO features a typical phase noise of -119 dBc/Hz @ 10 KHz offset and has excellent linearity. Output power is typically +2.5 dBm.