Test and Measurement Channel

A Fully-integrated 5 GHz 0.18 µm CMOS VCO for 802.11a WLAN Applications

This article presents a fully-integrated 5 GHz CMOS voltage-controlled oscillator (VCO) for a U-NII band 802.11a WLAN application. The VCO core circuit uses only PMOS fabricated with the 0.18 mm 1P6M standard CMOS process to obtain better phase noise p...
Due to the fast growing demand for broadband wireless communications, the operating frequency is moving toward the 5 GHz U-NII band. With a maximum data rate of 54 Mbps, the IEEE 802.11a wireless LAN (WLAN) standard specifies a 300 MHz allocation of spectrum in the 5 GHz range that...
Read More

Understanding W-CDMA Modulation Quality Measurements

There are many ways of characterizing W-CDMA transmitter performance. However, the Third Generation Partnership Project (3GPP) specifications require two measurements to verify the in-channel modulation quality of W-CDMA transmitters - error vector magnitude (EVM) and peak code domain power (peak CDE). This article explores the purpose behind these key...
Read More

Active Multipliers and Dividers to Simplify Synthesizers

A new family of active frequency multipliers and dividers is featured this month
Modern frequency synthesis uses a combination of frequency multiplication and frequency division to generate the required data and carrier signals for microwave radio and radar applications. Frequency multiplication increases the carrier frequency while increasing the phase noise of the carrier by 20log(N), where N is the multiplication factor. Conversely,...
Read More

Precision Eb/No Generators for BER Testing to 44 GHz

With the continually increasing complexity of digital modulation techniques employed in wireless and satellite communications systems, instruments that accurately generate and maintain a set level of bit energy-to-noise density ratio (E b /N o ) have become valued tools in optimizing bit-error rate (BER) performance. These instruments have been...
Read More

A Broadband Hybrid Solid-state and TWT Amplifier

Development of a broadband microwave amplifier for testing in the 800 MHz to 18 GHz frequency range
Test applications that require microwave power from 1 to 18 GHz are usually addressed by two amplifiers, a solid-state unit to cover the low frequency range and a traveling-wave tube amplifier (TWTA) for the higher range. The input signal must be switched between the two amplifiers and, if there...
Read More

SAW Voltage-controlled Oscillators

Presentation of applications that use voltage-controlled surface acoustic wave oscillator technology to provide high performance telecom solutions
Voltage-controlled surface acoustic wave (SAW) oscillators (VCSO) have been used for many years in both commercial and military applications. The low phase noise allows frequency multiplication to higher frequencies for use as sources, such as local oscillators in radar and other microwave systems. The excellent tuning linearity provides outstanding...
Read More

A Simulation Builder for Versatile Framework Integration

Introduction to a versatile simulation builder designed to integrate industry-strength simulation technology with external design frameworks
As the complexity of wireless systems grows and requirements become more demanding, the task facing analog/RF engineers is not getting any easier. In today's rapid-paced working environment, time-to-market demands accurate and fast results from device simulations. To meet these demands for the effective management and analysis of design data...
Read More

A Revolution in the Time Domain

A new modeling and design package for time domain software is featured on this month's cover
CST MICROWAVE STUDIO® Version 4 (CST MWS) is a major new release of the company's flagship 3D EM microwave modeling and design package. Over 1400 changes, enhancements and new features have been added to make this already powerful tool truly comprehensive and an invaluable resource. The microwave design engineer...
Read More
See More Videos