Test and Measurement Channel

Cavity Techniques for Substrate Properties at Microwave/Millimeter-wave Bands

For quality control in the design of microwave and millimeter-wave circuitry and devices, it is important to have a good measure of the dielectric properties of the materials employed. The standards and methods that are often employed for this purpose ...
The setups presented are essentially of two types - thin dielectric sheet testers and z-axis testers. These are the tools that are employed to independently measure the components of the substrate dielectric constant. It is supposed that suitable propagation models may use this information to better predict propagation mode...
Read More

Recent Advances in EDA Software Solutions for Improved RFIC Design Flows

Today's wireless world requires unrelenting technological innovation. From cell phones that take and send photos to homeland security, the demands on wireless designers for increasing complexity at lower prices and faster time-to-market are immense. Advances in electronic design automation (EDA) over the last decade have made possible dramatic improvements...
Read More

Cross-modulation in a CDMA Mobile Phone Receiver

Determining cross-modulation interference is an important factor in the design of a code division multiple access (CDMA) mobile transceiver. The cross-modulation interference level directly affects the performance of the receiver's ability to overcome the spurious interferences, such as what the IS-98 1 calls single tone desensitization. A few papers...
Read More

The Concept of Predistortion

The intention of this article is to provide a tool for the design of a predistorter, a component intended to correct unwanted nonlinear effects in power amplifiers. In order to come up with a design, a concept of predistortion is discussed. The conclus...
This article continues the trend of previous publications, 1,2 to simplify the prediction of RF performance of systems designed for wireless digital communications. The first shows the correlation between sidelobes and intermodulation (IM) products. Sidelobes are the result of the spectrum re-growth when a digitally modulated signal is applied...
Read More

Application of GTEM Cells to Wireless Communication Transceiver Designs

The GTEM cell has been widely accepted as a sufficient tool in electromagnetic compatibility for both radiated susceptibility tests and radiated emission tests. In this article, the relationships among basic quantities such as input power, electric fie...
The gigahertz transverse electromagnetic mode (GTEM) cell was first proposed in 1987 1 and subsequently patented in 1989 by D. Konigstein and D. Hansen 2 as a high frequency variant of the transverse electromagnetic mode (TEM) cell, which is also known as the Crawford cell. 3 The GTEM cell...
Read More
See More Videos