Microwave Journal
www.microwavejournal.com/articles/21440-lte-low-noise-amplifiers-and-lna-banks-from-infineon

LTE low noise amplifiers and LNA banks from Infineon

January 27, 2014

Infineon Technologieshas introduced a new series of LTE low noise amplifiers (LNA) and Quad LNA banks specially designed to enhance the data rate in smartphones. 

Meeting user expectations for high data rates in LTE is challenging in today’s mobile devices. The increasing complexity of the RF front end results in the usage of more RF components (e.g. switches, diplexers and dividers). This leads to increasing losses over the whole system and deterioration of the signal-to-noise ratio (SNR). Furthermore, the distance between antennas and the RF transceiver leads to additional line losses that also negatively affect SNR and consequently also data rate.

Infineon’s BGA7x1N6 and BGM7xxxx4L12 families provide low noise figure, the exact gain and high linearity needed to help smartphone designers overcome these challenges. The products are based on the company’s advanced SiGe chip technology and include built-in ESD protection.

The new LNAs and LNA banks are located in both the diversity and main antenna path of the phone, in order to increase system sensitivity and assure the best possible user experience. They allow for data rates that are up to 96 percent higher than in solutions without LNAs to fully exploit the potential of LTE. High linearity of the new device series assures optimal signal reception even in conditions of poorly isolated antenna and long line losses between antenna and transceiver.

The typical sensitivity improvement of 3.4 dB compared to systems without LNAs is achieved in devices with a package size 70 percent smaller (1.1 mm x 0.7 mm) than previously available LNAs and 61 percent smaller (1.9 mm x 1.1mm) than previously available LNA banks.