- Buyers Guide
To amplify weak signals received by the antenna in communication systems, low noise amplifiers (LNAs) are deployed. LNAs are used in various applications such as GPS receivers, wireless data systems, satellite communications, cellular handsets, radio systems, etc.
RF transmitters are an essential part of modern communications. Designed and assembled from core RF components, RF transmitters have many different forms and applications. We often think of RF transmitters in wireless communications, but the concept applies equally to wired applications such as cable television.
In this guide, the concept of calibration is presented and discussed in detail. Specific topics to be covered include how to configure the VNA for calibration, types of calibration and calibration kits. A minimal amount of calibration mathematics and theory will also be covered.
The airwaves are becoming increasingly crowded as demand for RF spectrum continues to grow. As a result, every type of wireless communication system faces a complex and unpredictable signal environment.
Cable and antenna measurements are often required to verify and troubleshoot the electrical performance of RF and microwave transmission systems and antennas. Measurements are often made along the coaxial cable connecting a transmitter to its antenna and/or between an antenna and its receiver.
This artice is the second half of a detailed discussion of noise factor for modern RF radio receivers. In Part 1 we discussed the general concept of noise figure and how it is used to convey noise-performance requirements by product definers and circuit designers. It is also used to predict the overall sensitivity of receiver systems. We also presented calculations for a cascaded receiver. In this continuation article we focus on the Y-factor measurement as it applies to mixers. We state which measurement is applicable to the cascade equations derived in Part 1. We also explore some variations of the measurement method the could be used to obtain an approximation to the SSB noise figure of a mixer.
This article ties together the fundamenal definition of noise figure, equation-based analysis of cascade blocks involving mixers, and typical lab techniques for measuring noise figure. In this Part 1 we show how the cascaded noise figure equation is modified by the presence of one or mixers and we derive the applicable equations for a number of popular downconversion architectures. We continue this discussion in Part 2 of this series where we describe the Y-factor method of noise-figure measurement. In Part 2 we focus on the case of a mixer as the device under test in order to identify appropriate measurement methods for mixer noise figures that can be validly applied using the cascade equations derived in Part 1.
The new application note “Solutions for Design and Test of 8x8 LTE MIMO” is designed to help you get insight into solving tough measurement problems in a unique way for both the design and manufacturing environments by explaining how to combine simulation with test solutions to realize high-performance 8x8 MIMO designs.
Trying to increase battery life? Trying to be green or increase energy efficiency? If so, then current consumption is most likely one of your key concerns. Today's multi-tasking, battery-powered devices boast powerful processors, incorporate back-lit touch-screen displays, and have amassed multiple radio receivers and transmitters that are sending and receiving data at unprecedented rates.
This paper explains the pulsed RF operation of Microsemi pulsed GaN HEMT RF power transistors using as an example the 1011GN-700ELM 1030 MHz Mode-S Enhanced Message Length (ELM) avionics device. General descriptions are presented detailing both the pulsed gate bias operation and the bias sequencing operation of the “pulser” circuit used on the Microsemi evaluation test fixtures.
Get access to premium content and e-newsletters by registering on the web site. You can also subscribe to Microwave Journal magazine.