advertisment Advertisement
This ad will close in  seconds. Skip now
advertisment Advertisement
advertisment Advertisement
advertisment Advertisement
advertisment Advertisement

Industry News

Accurate Power Detection of a CDMA Multi-carrier Power Amplifier Using a Logarithmic Amplifier

The accurate detection of the power output of a multi-carrier CDMA power amplifier enables the enhancement of power efficiency and harmonic suppression. Even though CDMA carriers with equal total power are applied, the experimental results, using a log...
In a typical multi-carrier power amplifier (MCPA) application, it is well known that good amplitude matching and good phase matching are required for greater reduction of intermodulation distortion (IMD) or for better harmonic rejection within the CDMA spectral mask. To solve the mismatching problem, it is desirable to accurately...
Read More

High Performance Wideband MSAG Gain Block/Driver Amplifier MMICs Using MLP Technology

The multi-level plating (MLP) process has been used to develop a family of wideband, low noise, generic gain block and driver amplifier MMICs operating up to 20 GHz. MLP implementation provides significant performance improvements over standard MMIC pr...
Wideband, low noise, generic gain block and driver amplifier MMICs have been developed using many different device technologies including MESFET, HBT and PHEMT. Among these, PHEMT-based MMIC technologies have achieved superior performance due to inherent device high frequency operation capability. In order to achieve superior performance similar to PHEMT...
Read More

Remote Sensing Through Satellites: A Tutorial Review

Remote sensing is a multi-disciplinary activity that deals with the inventory, monitoring and assessment of natural resources, following the analysis of data obtained through observations from a remote platform. This technology, under development since the early 1960s, has shown great promise in improving the information collection regarding the world’s...
Read More

A Wideband MMIC-based Feedback Oscillator

Classic feedback oscillators have often been favored because of their low phase noise performance and wide frequency tuning characteristics. This article covers the basic theory of feedback oscillators, and shows how the addition of a vector modulator ...
The requirement for increased data rates in modern radio systems has led to higher order modulation schemes which, in turn, demand oscillators with lower phase noise. Meanwhile, manufacturers must also deliver low cost solutions covering many different frequency bands. These two criteria have generally been incompatible, since an improvement...
Read More

Remotely-tunable Notch and Bandpass Filters for Evaluating System Performance

Tunable notch and bandpass filters can be very cost-effective in high frequency measurement and communications applications, especially when it is necessary to frequently change notch or bandpass frequencies. The alternative is to have available a large number of filters for discrete frequencies that must be manually swapped in and...
Read More

Prescalers that Simplify X- and Ku-band Synthesizer Architectures

Microwave signals play an important role in modern communication architectures and radar applications. Used as carriers and signals for up and down conversion they have to comply with certain quality standards. The most important two are frequency drift, which is a measure of the long-term frequency stability, and phase...
Read More

Passive Sensors Using RF Backscatter

An application of RF backscatter to monitor passive (zero DC power) sensors is presented. The technique uses an RF signal, from a probing platform, to probe a passive sensor. The passive sensor contains a transducer that acts like an impedance to RF si...
Low power wireless sensors are receiving considerable attention due to their multiple applications in the commercial and military scenarios. Wireless networks of “power aware” smart sensors are being developed that are deployed and forgotten, 1 as well as the sensor elements themselves. Transducers integrated with radio transceivers and networking...
Read More

Cross-coupling in Microwave Bandpass Filters

The fast growing demand for microwave communication technologies, such as broadband wireless and satellite communication, point-to-point radio links, as well as a variety of radar systems, brings up stringent requirements to modern microwave filter design techniques aimed at minimization of electromagnetic interference, cross talks and jamming. The most critical...
Read More

A High Efficiency Class-F Power Amplifier Design Technique

In this article, a medium power pseudomorphic HEMT device is used in the design of a high efficiency class-F power amplifier (PA) operating at 900 MHz. The purpose of this article is to describe the design procedure of a class-F PA with a very low drai...
High efficiency microwave amplifiers with low supply voltages are required for mobile telecommunications services, such as GSM or DCS1800 systems. Theoretically, class-F power amplifiers (PA) can achieve 100 percent drain efficiency by maximally flattening the voltage and current waveforms of the active device. 1 By increasing the efficiency of...
Read More

Sign-In

Forgot your password?

No Account? Sign Up!

Get access to premium content and e-newsletters by registering on the web site.  You can also subscribe to Microwave Journal magazine.

Sign-Up

advertisment Advertisement